- 您现在的位置：买卖IC网 > Sheet目录1182 > 848 (B&K Precision)PROGRAMMER UNIVERSAL DEVICE
Software
This setting is saved to disk by command Options / Save
options .
Options / Log file
This options associates with using of Log window . All reports
for this window can be written into the Log file too. The Log
file name as REPORT.REP and the control program creates
this file in current directory.
Sets New caused deleting old Log file if exist and creating a
new file for reports. Sets Append adds all reports into existing
Log file. If file not exist, the new file will be created. Settings
are applied only at program start.
This setting can be saved to disk by command Options / Save
options . Default form is set to a using Log window without Log
file i.e. all reports will be displayed to a Log window only.
Options / Protected mode
Protected mode is special mode of program. When program is
in Protected mode, there are disabled program operation and
commands which can modify buffer or device settings.
Protected mode is used for prevent operator from modify buffer
or device settings due to insignificance. Protected mode is
suitable for the programming of a large amount of the same
type of devices.
There are two ways how to switch program to Protected mode:
1. by using menu command Options / Protected mode .
This command displays password dialog. User have to
enter password twice to confirm the password is correct.
After password confirmation program switches to
Protected mode. The entered password is then used to
switch off Protected mode.
2. by reading project, which was previously saved in
Protected mode.
To switch program from Protected mode to normal mode use
the menu command Options / Normal mode . The ”Password
required" dialog appears. User have to enter the same
password as the password entered during switch to Protected
mode.
Other way to cancel Protected mode of program is closing of
program, because program Protected mode is active until
program is closed. The next program start will be to Normal
(standard) mode (the only exception is case of project loaded
by command line parameter name of project and the project
was saved in Protected mode).
125
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
849055-1
CONN CAP PROTECTIVE W/O-RING LGH
849252-1
CONN LGH 1 1L DUST CAP
849253-1
CONN LGH 2 3 DUST CAP
849254-1
CONN LGH 4 DUST CAP
849587-9
CONN RCPT FOR LGH SOLDER
849611-1
CONN RCPT BULKHEAD STR SOLDER
850306-3
CONN RCPT MOLDED LGH-1 TIN-LEAD
850512-1
CONN LG 1/2 1/2L DUST CAP
相关代理商/技术参数
84-8
功能描述:电池座、电池扣和电池接头 9V Battery SNAP RoHS:否 制造商:Eagle Plastic Devices 产品:Battery Snaps 电池组电池大小:9 V 电池数量:1 端接类型:Snaps 颜色:Black 材料:Polyvinyl Chloride (PVC) 安装风格:Snap-In
848 100 55
制造商:Werma 功能描述:Bulk
848 110 75
制造商:Werma 功能描述:Bulk
848 120 55
制造商:Werma 功能描述:Bulk
848 200 55
制造商:Werma 功能描述:Bulk
848 300 55
制造商:Werma 功能描述:Bulk
848 320 55
制造商:Werma 功能描述:Bulk
848 420 55
制造商:Werma 功能描述:Bulk